Fluke 3000FC/1AC-II Electricians DMM Voltage Tester and Acce
$254.00
Technical Specs
Fluke 3000FC/1AC-II Electricians DMM Voltage Tester and Accessory Kit Specs
| Range 1 | Resolution |
| 45 Hz to 500 Hz | 500 Hz to 1 kHz |
| 600.0 mV | 0.1 mV |
| 6000 V | 0.001 mV |
| 60.00 V | 0.01 mV |
| 600.0 V | 0.1 mV |
| 1000 V | 1 mV |
| Function | Range |
| mV | 600.0 mV |
| V | 6.000 V |
| 60.00 V | 0.01 V |
| 600.0 V | 0.1 V |
| 1000 V | 1 V |
| Ω | 600.0 Ω |
| Diode test | 2.000 V |
| µF | 1000 nF |
| 10.00 µF | 0.01 µF |
| 100.0 µF | 0.1 µF |
| 9999 µF 1 | 1 µF |
| Function | Range 1 |
| mA AC (45 Hz to 1 kHZ) | 60.00 mA |
| 400.0 mA 3 | 0.1 mA |
| mA DC 2 | 60.00 mA |
| 400.0 mA 3 | 0.1 mA |
| Range | Resolution |
| 99.99 Hz | 0.01Hz |
| 999.9 Hz | 0.1 Hz |
| 9.999 kHz | 0.001 kHz |
| 99.99 kHz | 0.01 kHz |
| Maximum voltage between any terminal and earth ground | 1000 V dc or ac rms |
| Ω fuse protection from A inputs | 0.44 A (44/100 A, 440 mA), 1000 V FAST Fuse, Fluke specified part only |
| Display (LCD) | Update rate: 4/sec Votls, amps, ohms: 6000 counts Frequency: 10,000 counts Capacitance: 1,000 counts |
| Battery type | Three AA Alkaline batteries, NEDA 15A IEC LR6 |
| Battery life | 250 hours minimum |
| RF communications | 2.4 GHZ ISM Band |
| RF communication range | Open air, unobstructed: Up to 20m Obstructed, sheetrock wall: Up to 6.5m Obstructed, concrete wall, or steel electrical enclosure: Up to 3.5m |
| Temperature | Operating: -10 °C to 50 °C Storage: -40 °C to 60 °C |
| Temperature coefficient | 0.1 X (specified accuracy) /°C (28 °C) |
| Relative humidity | 0 % to 90 % (0 °C to 35 °C), 0 % to 75 % (35 °C to 40 °C), 0 % to 45 % (40 °C to 50 °C) |
| Altitude | Operating: 2,000 m Storage: 12,000 m |
| Electromagnetic compatibilty EMI, RFI, EMC, RF | EN 61326-1:2006, EN 61326-2-2:2006. ETSI EN 300 328 V1.7.1:2006, ETSI EN 300 489 V1.8.1:2008, FCC Part 15 Subpart C Sections 15.207, 15.209, 15.249, FCCID : FCC: T68-FDMMBLE IC: 6627A-FDMMBLE |
| Safety compliance | ANSI/ISA 61010-1 / (82.02.01): 3 rd edition CAN/CSA-C22.2 No 61010-1-12: 3 rd edition UL 61010-1: 3 rd edition IEC/EN 61010-1:2010 |
| Certifications | CSA, FCC, CE |
| Ingress Protection (IP) rating | IP54 |
| Pollution Degree | 2 |
| Size (H x W x L) | 4.75 cm x 9.3 cm x 20.7 cm (1.87 in x 3.68 in x 8.14 in) |
| Weight | 340 g (12 oz) |
| Operating principle | Senses the steady state electrostatic field produced by ac voltage through insulation without requiring contact to the bare conductor. A red glow at the tip and a beeping noise (if not switched OFF) indicates the presence of voltage. |
| Voltage sensing ranges | Nominally, 90 V AC to 1000 V AC or 200 V AC to 1000 V AC depending on model, 45 Hz to 405 Hz; also a 20 V to 90 V control circuit model |
| Detector tip style | Blade or round, depending on model |
| Light source | One high intensity red LED |
| Agency Approvals | c CSA us, CE, C-Tick |
| Safety Rating | 1000 V, CAT IV |
| IP Rating | IP 40 |
| Operating Temperature | -10 °C to 50 °C |
| Operating humidity ranges | 0 % to 95 % (0 °C to 30 °C) 0 % to 75 % (30 °C to 40 °C) 0 % to 45 % (40 °C to 55 °C) |
| Operating Altitude | 3000 meters |
| Batteries | 2 AAA alkaline batteries included |
Reviews (0)
You must be logged in to post a review.
Reviews
There are no reviews yet.